1. Clean the spot where you about to stick the Magnetic Heat-Conductor.
2. Tear off the No.1 film on the transparent protective film. Stick the protective film on the back of the device. Smooth out the air bubbles and make the protective film fit perfectly on the back of the device. Tear off the No.2 film on the transparent protective film.
3. Tear off the paper on the adhesive of the Magnetic Heat-Conductor. Stick the Magnetic Heat-Conductor on the protective film.
4. Press the Magnetic Heat-Conductor for 30 seconds. Let it stand for 1 hour before use.

• When removing the magnetic sheet, tear off the protective film from the device, and then discard the used protective film and the adhesive. Please keep the magnetic sheet properly for your next use.
• When using the magnetic sheet again, please use a new protective film and adhesive.